Table of Contents
Advertisement
Available languages
Available languages
4. Install three, 1.5V "C" batteries (not included) into the
battery compartment. Make sure the polarity of the
batteries is correct. Replace the battery compartment
cover.
AUTO
5. Slide the power switch to the AUTO position to activate
the motion sensor. When motion is detected, the light
will turn on. The light will stay on for a period of ten
seconds after all motion has stopped to prolong bat-
tery life.
NOTE: To extend the life of the batteries, this light only
works in the dark (nightime).
AUTO
PRESS TO CLOSE
208882-02
OFF
OFF
SIZE C
OPEN
Power Switch
6. Place the top rear of the light fixture over the wall
mounting plate and slide the fixture down onto the
wall mounting plate. Slide the light fixture down until
the bottom tab clicks and locks the light fixture into
place.
FINAL ADJUSTMENT
Adjusting the Lamp Heads:
If needed, gently grasp the lamp heads and move them
from side to side or up and down to adjust the light cov-
erage area.
3
Advertisement
Table of Contents
