Installing Your Television Set; Quick Installation - Philips Streamium Manual

Installing your television set

5 cm
FM ANT.

Quick installation

When you turn on the TV set for the first time,
a menu is displayed on screen.This menu
prompts you to select the country and language
for the menus:
Plug'n'Play
Country
GB
If the menu is not displayed, press and hold down
" "
the - and + keys on the TV set for 5
seconds to display the menu.
& Use the cursor
UP/DOWN
control to select your country and validate
with cursor .
RIGHT
If your country does not appear in the list, select
choice ". . . "
4
5 cm
5 cm
Language
English
on the remote
& Positioning the television set
Place your TV on a solid stable surface. To avoid
danger do not expose the TV to water, or a heat
source (e.g. lamp, candle, radiator). Do not
obstruct the ventilation grid at the rear.
é
Connecting the aerials
• Use the aerial connection lead supplied and
:
connect the socket situated at the bottom
of the TV to your aerial socket.
• Insert the radio aerial lead supplied into the FM
ANT socket located at the bottom of the TV.
• Connect the power lead to the television and the
mains plug into the wall socket (220-240 V/50 Hz).
• Arrange the leads by passing them through the
television stand. Replace the stand cover.
For connecting other appliances see page p.10.
"
Switching on
To switch on the set, press the on/off key. A
green indicator comes on and the screen lights
up. Go straight to the Quick Installation chapter.
If the TV remains in standby mode(red indicator),
#
press the P key on the remote control.
The indicator will flash when you use the remote control.
é Next select your language using the cursor
and validate with cursor
UP/DOWN
" The search starts automatically.All the available
TV programmes and radio stations will be
stored. This operation takes a few minutes.The
display shows the progress of the search and
the number of programs found. At the end of
the search, the menu disappears.
To exit or interrupt the search, press
programme is found, consult the possible solutions p. 12.
' If the transmitter or cable network sends the
automatic sort signal, the programs will be
numbered correctly. In this case, the installation
is complete.
( If this is not the case, you need to use the Sort
menu to number the programs correctly.
Some transmitters or cable networks broadcast their
own sort parameters (region, language, etc.). In this
case, indicate your choice using the cursor
UP/DOWN and validate with cursor RIGHT.
.
RIGHT
h
. If no