Xc3 Si Stem Steerer - Cannondale LEFTY SPEED DLR2 Owner's Manual Supplement

xc3 si stem-
steerer
Installation
1. Make sure both the upper and lower
Lefty clamp bolts are loose.
2. Make sure the headset parts are
assembled as shown (next page).
3. Position the Lefty clamps onto the
headtube as shown.
4. Insert Cannondale specific tool KT020/
through the bottom clamp, into the
head tube, and out the upper clamp.
5. Make sure the plastic ring (6) is on the
stem. Insert the bottom of the stem-
steerer onto the top of the tool.
6. Remove the cap (1) from the top of the
steerer. Use a rubber mallet to drive the
stem-steerer into the head tube until it
stops. Return the cap (1).
7. Clean and apply grease to the steerer
bolt threads and install into the bottom
of the stem-steerer. Align handlebar
and tighten the bolt to 9 N•m.
8.. Tighten the upper and lower clamp bolts
to 9 N•m.
Removal
1 Loosen upper and lower clamp bolts.
2. Remove steerer bolt (10).
3. Insert the small end of KT020/ into the
bottom of the stem-steerer and drive
the stem-steerer up out of the head
tube.
22
STEM
STEERER
TOOL
KT020/
APPLY
GREASE
TO
THREADS
OF
BOLT