Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for KIRAMI FinVision
Summary of Contents for KIRAMI FinVision
- Page 1 INSTRUCTION MANUAL Kirami® FinVision Sauna Check the contents of the delivery without delay! Study the instructions carefully and keep them for future reference. Kirami Oy Villiläntie 2 tel. +358 10 574 2170 info@kirami.fi FI-32730 Sastamala fax +358 3 513 5561...
- Page 2 INSTRUCTION MANUAL: Kirami FinVision sauna 2 / 25...
- Page 3 INSTRUCTION MANUAL: Kirami FinVision sauna 3 / 25...
- Page 4 INSTRUCTION MANUAL: Kirami FinVision sauna 4 / 25...
- Page 5 INSTRUCTION MANUAL: Kirami FinVision sauna 5 / 25...
- Page 6 INSTRUCTION MANUAL: Kirami FinVision sauna 6 / 25...
-
Page 7: Checking The Delivery
GENERAL INFORMATION Kirami’s FinVision sauna shows the high-class finish of a master craftsman. The sauna is already surface-treated; it is made out of plain sawn softwood and spruce plywood. The product is intended for outdoor use only. -
Page 8: Installation
The discharge corner outlet pipe is 50 mm at the top. We recommend that you learn about the local regulations concerning the treatment of wastewater. INSTRUCTION MANUAL: Kirami FinVision sauna 8 / 25... - Page 9 Attach the roofing sides of the sauna using (5) terrace screws. plywood (1) first to the ends of the sauna using terrace screws (5). The plywood sheets have places reserved for the screws. INSTRUCTION MANUAL: Kirami FinVision sauna 9 / 25...
- Page 10 6. Attach the metal flashing (12) to the front attached. If you have ordered version of the sauna using roofing screws (16) with wood heated sauna stove, install chimney at this point. Kirami Oy Villiläntie 2 tel. +358 10 574 2170 info@kirami.fi FI-32730 Sastamala fax +358 3 513 5561 www.kirami.fi...
- Page 11 (you can use a rubber mallet to help with the attachment). 9. Using roofing screws (16), attach the 10. Attach sealings for flashing piece on flashing to right (10) and left side (11). top of the roof. INSTRUCTION MANUAL: Kirami FinVision sauna 11 / 25...
- Page 12 (see image). However, the customer must ensure that there are no flammable materials, such as wood or textiles, close to the sauna heater. INSTRUCTION MANUAL: Kirami FinVision sauna 12 / 25...
- Page 13 The fire grates last longer and draught remains good when the sauna heater is well cared for. Do not forget to empty the ashes into a non-combustible container and let them cool for approximately one day. INSTRUCTION MANUAL: Kirami FinVision sauna 13 / 25...
- Page 14 FLUE In Kirami’s FinVision sauna, we use the wood-burning sauna heaters and fireproof flues by the Finnish sauna heater manufacturer Narvi. Read more about the fireproof Narvi ® flues at the following link (in Finnish): http://www.narvi.fi/upload/dokumentit/narvihormi/narvihormi.pdf...
- Page 15 3. Install chimney valve section (i). It’s 4. Place the basket for stones around the recommended to place sauna stones after connecting pipe and fill it with smaller this. stones. INSTRUCTION MANUAL: Kirami FinVision sauna 15 / 25...
- Page 16 8. Ceiling duct insulation (f) on its place. between duct casing and chimney. 9. Place ceiling underlay (d) around the 10. Attach the underlay with insulating chimney. It will seal and support the tape. chimney. INSTRUCTION MANUAL: Kirami FinVision sauna 16 / 25...
- Page 17 Remember to add section and attach the hat with two screws. silicon between chimney section and Lock the chimney hat over bending the chimney hat. stripes on top of the hat. INSTRUCTION MANUAL: Kirami FinVision sauna 17 / 25...
- Page 18 Empty the ashes from the sauna heater after each use to ensure that the fire grate/grates or air dampers are not covered by ash. Ash shortens their service life considerably. See detailed instructions on fire grates and their maintenance in the instructions of the sauna heater in question. INSTRUCTION MANUAL: Kirami FinVision sauna 18 / 25...
- Page 19 - The On/Off LED is lit red whenever the heating elements are turned on; at all other times it is lit green. During the preset time, the On/Off LED is not lit. On/Off indicator light Preset timing (yellow) Power-on time (green) Temperature (red) INSTRUCTION MANUAL: Kirami FinVision sauna 19 / 25...
- Page 20 The LED lights only consume a small amount of electricity, which means that mood lighting can be on even if the sauna is not in use. INSTRUCTION MANUAL: Kirami FinVision sauna 20 / 25...
-
Page 21: Recommended Accessories
In Finland, we also use a sauna whisk during the summer. The sauna whisk is bound out of birch twigs, and we Finns use it to gently whip ourselves. Using the whisk improves the circulation of blood in the body. INSTRUCTION MANUAL: Kirami FinVision sauna 21 / 25... - Page 22 Alternatively, the outer surface can be treated with Pinotex classic 21 (colour code 6103-Y67R ‘Järkäle’ (boulder) (EU)) ‘harmaaleppä’ grey alder wood oil. INSTRUCTION MANUAL: Kirami FinVision sauna 22 / 25...
-
Page 23: Other Safety Issues
We recommend using environmentally friendly cleaning agents such as Kirami’s Biowash for washing the sauna. Rinse the sauna walls, benches and floor well after washing; you can also use a garden hose to spray water on the surfaces in question. -
Page 24: Warranty
KIRAMI OY WISHES YOU A DELIGHTFUL SAUNA EXPERIENCE! We reserve the right to make changes to the product without a separate notice. - Page 25 Kirami Oy YouTube channel https://www.youtube.com/channel/UCZ99_3iXnZZRn9bpkp4UpAg Kirami Oy Instagram You can find us on social media with the hashtag #Kirami You can find spare parts and bathing accessories easily from our webshop: kauppa.kirami.fi INSTRUCTION MANUAL: Kirami FinVision sauna 25 / 25...
Need help?
Do you have a question about the FinVision and is the answer not in the manual?
Questions and answers