3 Maintain the ATCA Subrack
3.6.3.1 Remove JAXSMM
54 / 90
JAXSMM
OOS
OK
OK (Power) LED
ACT
H/S
H/S (Hot Swap) LED
Handle switch
Ejector ring
Figure 19: Shelf Manager Board
To remove a JAXSMM card:
1. Identify the board to be replaced. Refer to Board/Area/Slot/SBL Mapping
(Section 1.3) for details.
2. Check if the JAXSMM which should be removed is in stand-by
3. Lock the JAXSMM if it is active
4. The blue LED blinks indicating that the board power down process is ongoing
5. Wait until the blue LED is ON permanently
6. Unfasten screws of front plate until handle switch is detached from front
plate of the board
7. Remove board from shelf using the ejector ring.
3BK 21281 AAAA PCZZA Ed.13