Table of Contents
Advertisement
4 C
HECKS BEFORE STARTING THE MACHINE
4.1 Overall visual inspection
If there is any fuel on hot areas or if there are any fuel and/or oil leaks, this may cause a
fire. Carefully check these possible causes of fire. If there are any faults, contact your
1 Check the hydraulic components : wear and leaks around the cylinders, damage to the ho-
ses and connectors come loose.
Clean the dust and combustible materials (dead leaves, chips) on areas where heat deve-
2
lops : around the engine, the battery and the radiator.
3 Check that there are no oil leaks from the engine or water leaks from the cooling system.
Check that there are no oil leaks from the hydraulic system, the hydraulic oil tank, the pi-
4
pes and seals.
5 Check that there are no traces of grease or leaks from the hydraulic pipes.
Check that there are no cracks, wear or play on the bolts and there are no oil leaks on the
6
track rollers (runners, sprockets and rollers).
7 Check that the bolts have not broken or come loose.
Check the proper operation and the condition of the operator display station.
• If nuts are loose, tighten them if necessary.
8
• If the screen is damaged, replace it with a new operator display station.
• Clean the surface of the operator display station.
Check that the red ring on the water decantor is pushed onto the lower part of the bowl. If
9
the ring floats in the bowl, this means that water has mixed with the diesel. In this case, ta-
ke out the bowl and remove the water.
WARNING
dealer.
81
Advertisement
Table of Contents
