Table of Contents
Advertisement
Wire the cable reel cable directly to the A-2-B switch, if a 6 Pin Receptacle
is not used.
6.
Using 2 conductor Olflex cable wire from the bottom of the receptacle to the A-2-B switch.
Refer to wiring diagram included with this publication. The wiring shown is for a Main
Boom installation only.
7.
DO NOT loosen the cable reel lock nuts. Leave slack in the cable from the Boom head.
8.
Move to the cable reel and complete the wiring for the A-2-B, Angle transducer and Length
transducer, if this is an HLAP installation. Refer to the Wiring diagrams included with this
publication.
9.
Install either the 5 conductor or 10 conductor cable in
the Boom Pivot receptacle. Wire as described in the
wiring diagram included with this publication.
10. Make up either a 6 Pin or 10 Pin Plug with either 5
conductor or 10 conductor cable. The cable should be
long enough to be routed along the machine structure
to the Control Panel mounted in the crane cab.
Route cable to ensure that cable is not crimped
or can be stepped on in the normal course of
machine operation.
11. Secure the cable in position with stand offs and tie wraps, as needed.
12. Install cable in panel and wire to terminal strips in the panel. Refer to the wiring diagram
included with this publication.
13. Install a piece of 2 conductor Olflex cable from panel to the power source of the crane.
Connect the power side to the power source. The preferred connection is the run side of
the ignition key switch. Connect the ground wire to a cleaned ground lug on the machine
structure.
DO NOT APPLY POWER TO THE SYSTEM AT THIS TIME. POWER
WILL
BE
CALIBRATION PROCEDURE.
PANEL
VOLTAGE
I D E N T I C A L .
Page 6
NOTE
C A U T I O N
APPLIED
AS
PART
AND
CRANE
PAT America, Inc.
NOTE
OF
THE
CHECK
THIS WILL ENSURE THAT THE
SYSTEM
To Control Panel
P
L U G
From Cable Reel
R
E C E P T A C L E
Remove Cable Connector
and install Plug.
OUT
AND
VOLTAGE
ARE
H(L)AP - AA 103 - Install (RE699)
Advertisement
Table of Contents
