Table of Contents
Advertisement
base section to protect the cable.
If conduit is not used, secure the cable to the boom structure using stand offs and tie
wraps.
INSTALL THE CABLE INTO THE RECEPTACLE WITH THE CABLE
ENTERING FROM THE LOWEST POINT OF THE RECEPTACLE
WITH THE BOOM IN ITS NORMAL OPERATING POSITION.
2.
Remove the cable reel cover. Remove the nut and rubber grommet from the center shaft.
Route cable through the mounting bracket and into hole in the cable reel center shaft.
Replace the rubber grommet and nut, tighten nut. Install the cable reel into the mounting
bracket and tighten the bolt in the mounting bracket to lock the cable reel in place.
DO NOT LOOSEN SPRING LOCK NUTS,
AS
CABLE
TENSION,
INSTALL
CABLE
OR
WITH A DRIP LOOP TO REDUCE THE
POSSIBILITY OF WATER ENTERING THE
CABLE REEL HOUSING.
3.
Unwrap sufficient cable from the cable reel to reach the strain relief anchor on the boom
head.
Take care to keep any twists out of the cable reel cable.
4.
Route the cable through the roller guides and attach the strain relief assembly to the
anchor bracket on the boom head.
Do not put a twist in the cable reel cable between the reel and strain relief
anchor. Twisted cable will result in accelerated wear.
5.
If a 6 Pin Receptacle is installed at the boom head, pull the cable reel cable through the
P clamps on the receptacle and into the bottom of the receptacle. Wire as shown on the
Wiring diagram included with this publication.
H(L)AP - AA 103 - Install (RE699)
C A U T I O N
C A U T I O N
REEL
SPRING
WHEN
SHIPPED.
EITHER
THE
5
CONDUCTOR
10
CONDUCTOR
PAT America, Inc.
IS
UNDER
Spring Lock Nut
CABLE
NOTE
NOTE
Cable Reel Mounting Bolt
Page 5
Advertisement
Table of Contents
