Quark-Elec QK-A027 Setup Manual

QK-A027
6. Connect via WiFi if desired
You can connect to our wireless products in 2 ways...
Ad-hoc mode WiFi or
Ad-hoc mode WiFi (direct A027 to phone/tablet/PC) is the default setting, this requires no
Windows configuration.

On your device (phone/tablet/PC): 15 seconds after the A027 has powered up, you can scan
for a WiFi network with an SSID similar to 'QK-A027xxxx'. Connect the device to 'QK-
A027xxxx' with the default password: '88888888'.

In your chart software: set the protocol as 'TCP', IP address as '192.168.1.100' and the port
number as '2000' in the chart software.
Station mode WiFi (A027 through a router/access point - to phone/tablet/PC) allows you to
access your data at the same time as your other WiFi network data. This option requires
configuration to set up the connection between the A027 and your router. See the
'Configuration' section of the manual and configuration instructions on the CD provided.
7. You can adjust baud rates if needed
To change the baud rate from the default settings (input 4800bps and output 38400bps), adjust
these settings using the Configuration software.
See the 'Configuration' section of the manual and configuration instructions on the CD provided.
Disclaimer: This product is designed to aid navigation and should be used to augment normal navigational
procedures and practices. It is the user's responsibility to use this product prudently. Neither Quark-elec, nor
their distributors or dealers accept responsibility or liability either to the product user or their estate for any
accident, loss, injury or damage whatsoever arising out of the use or of liability to use this product.
Email: info@quark-elec.com
V1.1(10/19) Note: SeaTalk™ is a registered trademark of Raymarine.
Station mode WiFi
QK-A027
WIRELESS AIS RECEIVER
WITH GPS + SEATALK™ CONVERTER
SET-UP GUIDE

What You Need

Installation Overview

Notes
All products are CE, RoHS certified
www.quark-elec.com
Please recycle your packaging