10 Operating Instructions and Installation
5
5
. AUTO button (Available in Analog mode only)
When the 'AUTO' button is pressed, the Auto
Adjustment screen appears as shown in the ani-
mated screen on the center. Press to self-adjust to
the incoming Analog signal. The values of
fine,coarse and position are adjusted automatical-
ly.
6
6
. MENU button
Opens the OSD menu.
Also use to exit the OSD menu or return to the pre-
vious menu.
10-2 Rear
10-2
7
7
. Power button
Use this button for turn the monitor on and off.
P
P
ower indicator
This will enable you to see the overall power status
of the system. For more information, see the
PowerSaver section.
1. DVI
DVI-I / DVI-D
Connect the DVI Cable to the DVI(DVI-I or DVI-D port on the
back of your monitor.
2. Stand Stopper
Remove the fixing pin on the stand to lift the monitor up
and down.