Do you have a question about the MCFRC103 and is the answer not in the manual?
Questions and answers
Silas Kainge
May 9, 2025
the motor does not want to start
1 comments:
Mr. Anderson
May 19, 2025
The TRADEair MCFRC103 motor may not start due to the following possible causes:
1. Fault in the power line or insufficient voltage – check the line. 2. Power wire is too thin or too long – replace the wire. 3. Faulty pressure switch – repair or replace. 4. Fault in the motor – repair or replace. 5. Sticking of the main compressor – check and repair. 6. Inner thermal protector on the motor has cut off – turn off the power, wait 10–15 minutes for the motor to cool, then restart.
Belt driven air compressors.
aluminum pump & single-phase rang.
w-type cast iron pump & single-phase range.
w-type cast iron pump & three-phase range (21 pages)
Need help?
Do you have a question about the MCFRC103 and is the answer not in the manual?
Questions and answers
the motor does not want to start
The TRADEair MCFRC103 motor may not start due to the following possible causes:
1. Fault in the power line or insufficient voltage – check the line.
2. Power wire is too thin or too long – replace the wire.
3. Faulty pressure switch – repair or replace.
4. Fault in the motor – repair or replace.
5. Sticking of the main compressor – check and repair.
6. Inner thermal protector on the motor has cut off – turn off the power, wait 10–15 minutes for the motor to cool, then restart.
This answer is automatically generated