JLab Audio GO AIR Manual page 3

CHARGING CASE
Connect the GO Air into a
computer or USB 5V 1A
(or less) output device.
FITTING
Try all ear tips for best
fit and proper seal.
CAUTIONS
• Avoid extreme heat, cold, and humidity.
• Avoid dropping or crushing the earbuds.
• Wax may build up in the earbud tips, lowering the sound quality.
Carefully remove the wax with a cotton swab or other small tool to improve the sound quality.
• If you experience discomfort or pain, try lowering the volume or discontinuing use temporarily.
• If you experience regular discomfort while using this product, discontinue use and consult your physician.
• We recommend you treat your earbuds as you would a nice pair of sunglasses and keep them in safe location when not in use.
Shop products
JLab Audio + Burn-in Tool
Fully
Charged
Place the earbud in the ear
canal and slightly rotate to
adjust for best fit.
| Product alerts | Burn-in your headphones
Charging
QUICK TIPS
• The left or right earbud can be used independently for music and
phone calls. Simply choose one and take out of the case to connect.
• Only ONE Bluetooth device can be connected at a time. Turn off
Bluetooth on unwanted devices and turn on Bluetooth on chosen
device to connect.
WARNING
Fully dry off the earbuds before
putting in the charging case to
avoid any damage to the case.
The earbuds are sweat/water
resistant but the case is not.
OR