Table of Contents
Advertisement
RAISING/LOWERING THE CONVEYOR TABLE
The conveyor table can be raised or lowered as needed to suit the thickness of the workpiece, by rotating the
wheel, A.
Note: The maximum workpiece thickness capacity for this machine is 3-3/4".
DOWN
A
1.
Put the workpiece on the conveyor belt.
NEVER ATTEMPT TO SAND WORKPIECES THAT
ARE GREATER THAN 3-3/4" IN THICKNESS.
CHANGING FEED SPEED
The conveyor speed ranges from 6 to 20 FPM (Feet Per
minute).
The feed speed adjustment knob, A, is located on the
control box, on the right hand side of the machine.
-
Turn the knob clockwise, B. to increase the feed
rate.
-
Turn the knob counter-clockwise, C, to decrease
the feed rate.
Experiment with feed speeds based on the workpiece
material, depth of sanding as well as sanding belt grit
to find which settings work best for your needs. As a
general guideline however, for best results, more
aggressive sanding using lower grits or sanding wider boards should be done at slower speeds and sanding using
higher grits or sanding narrow boards can be done at higher speeds.
12
UP
Note: the depth gauge, B ,on the front of the machine
can be used as a reference but it is not intended for
high precision measurements
DO NOT
B
* Effect exaggerated for clarity
2.
Set the height of the conveyor table so that the
work-piece barely touches the drum, C.
Note: To avoid overworking the motor, creating a po-
tential circuit overload, or damaging the sanding
drum, do not force the workpiece against or into the
drum.
DECREASE
SPEED
C
A
DO
C
DRUM
WORK PIECE
CONVEYOR BELT
INCREASE
SPEED
B
Hide quick links:
Advertisement
Table of Contents
