Philips VOIP8410B/05B Quick Start Manual

XtraHS_QSG_VOIP841_UK.qxd 12.07.2007 18:35 Seite 1
What's in the box
Two 750mAh
AAA NiMH
batteries
Handset Battery door
Quick start guide User manual
W W h h a a t t e e l l s s e e w w i i l l l l y y o o u u n n e e e e d d
A VOIP841
Connect
1
Connect the charger
A
Power supply for
charger
Charger
Insert batteries
B
Charge handset
C
● Insert the plug of the charger
power adapter into the socket on
the bottom of the charger.
Plug the power adapter into your
●
power outlet.
● Place the 2 rechargeable NiMH
AAA batteries, observing their
polarities, into the battery
compartment on the handset.
● Slide the battery door firmly into
place.
● Before first use, put the handset
on the charger and charge
batteries for 14 hours.
14
Install
2
A B
Register the handset Verify the signal strength
Registration allows communication
The signal icon
between the base unit and
status between the handset and the
handset(s). If the handset cannot
base unit.
communicate with its base, you will
Signal icon
not be able to make any call or use
unit are linked.They can communi-
many of the functions and features on
cate.
the phone.
No signal icon
Reg.
1.Press . Register shall be
base unit have lost link.They are not
highlighted.
able to communicate.Take your
2.Enter the system PIN (Default:
handset closer to the base unit to
Clear
0000). Use to correct typing
reconnect the link.
errors.
If you move too far away from the
Enter base unit while you are on the
3.Press to confirm.
phone, you will hear warning tones
● Your handset starts searching for
notifying you that the handset is
the base.
almost out of range - lost link.Take
4.Press on the base unit until the
the handset closer to the base unit
two indications turn off.
or your call will be cut off shortly
● If registration is successful, the
after the warning.
signal icon displays steadily.
Note :
Tip :
If your handset has lost link, you
If registration failed, repeat the
will not be able to make or
above procedure.
receive any call. In addition, you
will not be able to carry out
Note :
many of the phone functions and
The base can register up to 4
features.
handsets, then the base unit
registration memory is full. If you
attempt to register an additional
handset, the registration process
will be aborted.
displays the link
:The handset and base
:The handset and