Metro DataVac Flo Series Operation Manual page 4

Symbol Explanations
Important Safety Instructions
This document contains important safety and operating instructions for the Flo
and cautionary markings on the Laptop Cart before putting it into service.
Caution:
User maintenance consists of cleaning, minor external adjustments, periodic tightening of fasteners and the like. For
safety purposes, any and all servicing other than the procedures detailed in the Maintenance section of this manual
must be performed by qualified service personnel only. For all service items, please contact InterMetro Customer
Service.
Caution:
Do not operate a Flo
or otherwise physically damaged. Please have a qualified service person inspect all components of the Laptop Cart
for any performance or safety hazard prior to putting it back into service.
Caution:
TM
The Flo Series Laptop Cart is not designed for use as a general purpose equipment cart. Please do not apply
heavy loads to the cart top surface. The maximum design load (safe working load limit) for the Laptop Cart is 5 lbs.
Caution:
Ensure that the AC power cord is located and secured so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress. Please secure the AC power cord plug in the retaining clips provided on the
TM
Flo Series Laptop Cart when it is unplugged from the AC outlet in order to prevent accidental tripping and physical
damage to the cord plug or electrical insulation.
To prevent damage to any cords or connectors when disconnecting, always grasp and pull by the connector and not
the cord.
Do not operate the Flo
component immediately. Contact InterMetro Customer Service for replacement parts and service.
Caution:
To reduce the risk of electric shock, unplug the Flo
ON/Extended Storage Switch to the Extended Storage (OFF) position before attempting any maintenance or cleaning.
Turning off computers or disconnecting the AC power cord alone will not reduce the risk of electric shock because the
Power Supply is internally powered by a battery.
Warning: Risk of Electric Shock - DC voltage output Power Supply (Series 1720)
The AC power cord is the only means to disconnect the Flo
The ON/Extended Storage Switch on the Power Supply does not disconnect from main power.
On the other side, the Power Supply employs a battery to provide mobile DC output power. Low voltage (10-16 VDC)
DC power is available from the Power Supply, even when the AC cord is disconnected from an AC outlet. To remove
DC power, put the ON/Extended Storage Switch in the Extended Storage (OFF) position.
Warning: Risk of Electric Shock - AC Inverter Power Supply (Series 1520)
The AC power cord is the only means to disconnect the Flo
The ON/OFF switch on the Fuel Gauge controlling the AC Power Supply does not disconnect from main power.
On the other side, the Power Supply employs a battery to provide mobile AC output power. High AC voltage
(120 or 230 VAC nominal) and current is available from the Power Supply, even when the AC cord is disconnected
from an AC outlet. To remove AC power, press the ON/OFF switch on the Fuel Gauge for at least 2 seconds and
ensure all the LEDs turn off.
DANGER: Risk of Explosion
TM
The Flo Series Laptop Cart and the Power Supply are not for use in hazardous (classified) locations. Do not use
TM
the Flo Series Laptop Cart, nor recharge the Power Supply battery if so equipped in oxygen enriched areas; areas
where flammable anesthetics are used or stored; or any other hazardous, classified location.
4
Metro Flo
Attention, consult accompanying documents
TM
Series Laptop Cart if it has received a severe impact, been knocked over, fallen down stairs,
TM
Series Laptop Cart with damaged cords or connectors. Please replace the damaged
TM
Series Laptop Cart Operations Manual, Doc. No. L01-465 Rev A
InterMetro Industries Corporation
TM
Series Laptop Cart. Please read all instructions
TM
Series Laptop Cart AC cord from an AC outlet and switch the
TM
Series Laptop Cart from the AC power grid (mains).
TM
Series Laptop Cart from the AC power grid (mains).