Electrical Components - Big Joe PDBB-20-T12 Operation, Maintenance, Repair Parts List

10-1.BATTERIES.
NOTE: Batteries are removed from the right side of
the truck. When installing a new battery, be
sure handles are securely fastened to battery,
battery cables are securely attached to bat-
tery terminals, and cables are routed and
secured to the battery as shown in
Figure 10-1 or
CAUTION: Failure to properly route and wrap bat-
tery cables can damage cables and
make battery installation difficult.
1. Turn key to off, and remove from key switch.
R6197
901357

ELECTRICAL COMPONENTS

Figure 10-2.
Figure 10-1 Batteries and Emergency Power Disconnect
SECTION 10
NOTE: Batteries are heavy. Use care when sliding
out of battery compartment.
2. Remove screw (19), washer (21) and retainer bar
(22).
3. Remove batteries from the right side of the truck.
The battery connecting cables are sufficiently long
to allow batteries to be placed on the floor.
4. Disconnect cables (18) from battery terminals.
5. Connect cables (18) on terminals of new battery,
and slide battery back into compartment, being
careful not to damage cables.
6. Reinstall and position retainer bar (22) to prevent
battery movement in excess of 1/2".
USED ON TRUCKS
SERIAL NUMBERS
375067 TO 380099
10-1