Table of Contents
Advertisement
!
2.3.1. Driver Installation
Connect the board to a PC with a Micro-USB cable and install the USB-to-UART driver.
2.3.2. Flashing ESP32
In order to build examples of esp-va-sdk, please follow the instructions mentioned on
•
the
GitHub page.
Once you build the Alexa firmware, you will generate three artifacts: bootloader.bin,
•
partitions.bin and alexa.bin.
For Flash Download Tool users, follow the instructions given below:
•
1. Run Flash Download Tool, and click on "ESP32 Download Tool" at the interface.
See Figure 2-1 above.
2. Then you will see the interface shown in Figure 2-2 below.
Espressif
!
Figure 2-1. Flash Download Tool
4
! /16
2. Configuring for AVS
2019.07
Advertisement
Table of Contents
Need help?
Do you have a question about the ESP32-LyraTD-DSPG and is the answer not in the manual?