Advertisement
CDM-200A (Wiring-FM Modulator unit)
F M
M o d u l a t o r
To +12V
ACC,
S p e a k e r
D I N c o n n e c t i o n c o r d ( 6 p i n )
F M R a d i o
INTERFERENCE ON 89.1 MHz
If a clear signal cannot be obtained on 89.1
l
MHz, change the position of the frequency
select switch on the back of the FM Modula-
tor
and
tune the radio to 88.7 MHz when
using the CD changer.
Select a frequency before mounting the FM
l
Modulator.
Radio sensitivity is slightly reduced when the
FM Modulator is connected.
T o c a r a n t e n n a
Connect to where the cower is
supplied when the ACC power or
F u s e 5 A
Connect this lead to the cable to
which power is continuously supplied
and which has been passed through
the vehide's
fuse unit.
Ground lead (black)
S c r e w t h i i t o a m e t a l p e r t o f t h e
v e h i d e .
C D C h a n g e r
R C A L i n e o u t
To +12V
ACC,
S p e a k e r
D I N c o n n e c t i o n c o r d ( 6 p i n )
F M R a d i o +I,
Ground Isolator Switch
If noise is heard from the speakers when
operating DISC SELECT, TRACK UP,
TRACK DOWN etc, set the ground isolator
switch to ON of the ground isolator unit.
If the LINE-IN terminal of the car stereo
l
(car radio) set that you are now using is
an RCA type, please purchase a com-
mercially available RCA extension cable
for wiring.
F u s e 2 A
Connect to where the power ls
supplied when the ACC power or
ignition switch is turned ON.
F u s e 5 A
Connect thff lead to the cable to
which power is continuousty
and which has been passed through
the vehicle's fuse unit.
Ground fead (black)
Screw this to a metal part of the
v e h i d e .
C o m m a n d e r
supplied
Advertisement
