Advertisement
3. ASSEMBLY
3.1
YK30F.V2 30TON PRESS ASSEMBLY (use the exploded diagram (Fig.1) as a guide to assembly).
3.1.1
Attach the two upper cross beams (20) to the left and right posts (09) using bolts (16), washers (17), lock washers (18) and nuts (19).
3.1.2
Attach one of the base sections (01) to the left post and lower cross member (08) using bolts (07), washers (04), lock washers (05) and
nuts (06). Add two supports (02) to the post and base sections, using bolts (03), washers (04), lock washers (05) and nuts (06).
Repeat the operation for the right hand side.
3.1.3
Lifting from the upper cross beam end lift the press into an upright position.
WARNING! Ensure help is available and use slings and a suitable hoist or gantry to raise the press to an upright position.
3.1.4
Insert the bed frame pins (10) into the holes in each of the post, ensuring that they are level and then with the help of an assistant insert
the bed frame (11) into the press frame and rest on to the pins.
3.1.5
Attach the pump to the right hand post using bolts (25) and washers (26).
3.1.6
Attach the ram assembly to the upper cross beam using bolts (21), washers (04), lock washers (05) and nuts (06).
3.1.7
Connect the hydraulic hose (37) to the ram (15) (A to A) and assemble the pressure gauge (23) to the ram assembly (B to B).
Fig.1
YK30F.V2
Issue No: 1 - 20/10/08
Advertisement
