Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Award BV60BL
Summary of Contents for Award BV60BL
- Page 1 Wine / Beverage Preservation Technology INSTRUCTION MANUAL BV60S BV60BL WCDZ60S WCDZ60BL WCBV60BL WCDZ600TS WCDZ600TBL Thanks for buying one of our Wine or Beverage cabinets. Before use, please read and follow all safety rules and operating instructions.
- Page 2 WARNING The information in this document is subject to modification without prior notice. Some models are available in dedicated countries only. All warranties are void if the appliance is being used for any purpose other than that for which it was specifically designed. Warranty applies to the wine cellar only and not to the content of the wine cellar.
- Page 3 R600a WARNINGS For your safety observe the following recommendations. This appliance contains a small quantity of R600a refrigerant which is environmentally friendly, but flammable. It does not damage the ozone layer, nor does it increase the greenhouse effect. During transportation and installation, ensure that the tubing of the refrigerant circuit is not damaged.
-
Page 4: Installing Your Wine Cellar
Allow 24 hours before switching on the wine cellar. During this time we recommend that you leave the door open to clear any residual odors. BEFORE LOADING & PLUGGING IN THE WINE CELLAR Important: All models without front venting (air opening) are strictly for free standing only. - Page 5 The wine cellar must be positioned such that the plug is accessible. Release the power cord. Move your wine cellar to its final location. The wine cellar should be installed in a suitable place where the compressor will not be subject to physical contact. Leveling your wine cellar: Wine cellar must be leveled BEFORE loading your wines.
-
Page 6: Dimensional Drawings
WARRANTY. INSTALLATION DRAWINGS FOR BUILT IN WINE CELLARS: (UNDERBENCH OR IN COLUMN) FRONT VENTING WINE CELLARS ONLY Note: The appliance must be positioned so that the plug is accessible after installed. DIMENSIONAL DRAWINGS: BV60BL,BV60S,WCDZ60BL,WCDZ60S,... - Page 7 WCDZ600TS,WCDZ600TBL OPEN ANGLE SIZE DRAWINGS: BV60BL,BV60S,WCDZ60BL,WCDZ60S...
- Page 8 WCBV60BL WCDZ600TS,WCDZ600TBL...
- Page 9 RADIATOR SYSTEM DESCRIPTION BV60BL,BV60S,WCDZ60BL,WCDZ60S,WCBV60BL,WCDZ600TS,WCDZ600TBL Models use side anti-dew tube and Independent cooling system: TURNING ON YOUR WINE CELLAR Plug in and switch on the cellar by pressing on the power button for a few seconds. When you use the wine cellar for the first time (or restart the wine cellar after having it shut off for a long time), there will be a few degrees variance between the temperature you have selected and the one indicated on the LED readout.
- Page 10 - Cracking/popping sounds - resulting from the contraction and expansion of the refrigerant gas to produce cold. - Fan operating sound - to circulate the air within the wine cellar. An individual’s perception of noise is directly linked to the environment in which the wine cellar is located, as well the specific type of models.
-
Page 11: Temperature Settings
TYPES OF REGULATION Please note that depending on the loading and settings chosen it takes about 24 hours for the wine cellar to see the temperature stabilizing. During this time LED seems to move erratically in particular, it is normal and this process occurs whenever the setting is modified and/or whenever a large amount of bottles are added to the cellar. - Page 12 In the boot state: short press this button, LED lights on / off switch In the boot state: press the button for 3 seconds, the power is off, the machine is off. BV60BL,BV60S:SNGLE TEMPERTURE DISPLAY BOARD OPERATING INSTRUCTION: From left to right: ...
- Page 13 ② ON/OFF the power button: In the standby mode: press 3 seconds, the power is turned on, the whole machine starts In the power-on state: press the power button, window 4 shows the countdown 3 2 1, the power is turned off, the machine is turned off (show 3 2 1 process, the hand cannot leave the button) ...
- Page 14 Press the button 3 seconds to power off (Window ④ digital countdown displays 3, 2, 1,). Press again (without delay), the power turns on. ② Upper zone temperature setting up button: Press one time, window ④ the set value will increase 1 degree Celsius in the original setting temperature, the setting range according to customer requirements.
- Page 15 WINE SERVING TEMPERATURE CHART All wines mature at the same temperature, which is a constant temperature set between 12ºC to 14ºC. The below chart is an indicative temperature chart to indicate the best temperature for drinking purposes. Champagne NV, Sparkling, Spumante 6ºC Dry White Semillon, Sauvignon Blanc 8ºC...
- Page 16 DEFROSTING/CONDENSATION/ HYGROMETRY/ VENTILATION Your wine cellar is designed with “Auto-cycle” defrost system. During “Off-cycle” the refrigerated surfaces of the wine cellar defrost automatically. Defrost water from the wine cellar storage compartment drains automatically and part of it goes into a drainage container, which is located at the back of the wine cellar next to the compressor.
- Page 17 extract and remove the shelf from the other side of support bracket②, then take off the shelf following the arrow mark ③. Shelf installation will be opposite with shelf taking. 、”A” is shelf limit pin 2、”B” is shelf Sliding wooden shelf installation and taking instruction: Shelf taking: According to below instruction drawing to pull out the shelf to support bracket ①, press two sides of sliding roller buckles and pull out the shelf following the arrow mark ②.
-
Page 18: Reversibility Of The Door
REVERSIBILITY OF THE DOOR BV60BL,BV60S,WCDZ60BL,WCDZ60S,WCBV60BL,WCDZ600TS,WCDZ600TBL will use same method to install the door 1. To put the cabinet on open operation place, the door opened to the maximum angle 2. - Page 19 1.Decorative nail 2. Knife 3. Drop-proof device 4. M5 six angle 5. M5 six angle screwdriver 6. Door spindle core 7. Upper door hinge 8. Lower door hinge Handle Installation Method 1. Take out handle from cabinet, then take out 4pcs 4 * 35 screws from accessory bag 2.
-
Page 20: Operation Anomalies
If the screws holes of the handle don't match perfectly with the holes of the door ,please use the electric drill to drill the holes of the door a bit big ( in surface side) , in order to install the handle perfectly . OPERATION ANOMALIES Ensure that there is power to the electrical supply plug by connecting another electrical appliance to it. -
Page 21: Power Failures
POWER FAILURES In the event of a power interruption, all previous temperature settings are automatically retained and it will revert to a preset temperature setting. Most power failures are corrected within a short period of time. An hour or two’s loss of power will not affect wine cellar’s temperatures. - Page 22 seems to make normal. too much noise. As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your Wine cellar. Contraction and expansion of the inside walls may cause popping and crackling noises. The Wine cellar is not level. The door will The Wine cellar is not level.
Need help?
Do you have a question about the BV60BL and is the answer not in the manual?
Questions and answers