Advertisement
Important Safety Information
Do not conceal or extend bus bar conductors through a
building wall.
Do not install this lighting system in a damp or wet location.
To reduce the risk of fire and burns, do not install this
lighting system where the uninsulated open bus bar
conductors can be shorted or contact any conductive
materials.
To reduce the risk of the system overheating and possibly
causing a fire, make sure all the connections are tight.
Do not install fixture assemblies closer than six inches to
curtains or similarly combustible materials.
Turn the electrical power off before modifying the lighting
system in any way.
The fixtures used with the system must be identified to be
used with the corresponding system.
Minimum volume of the electrical box must be 6 cubic
inches (98 cubic centimeter).
The system is "ETL" listed for USA and Canada only when all
the products used are supplied by Tech Lighting.
It is important to wire the remote transformer for the system
as described in these instructions.
Load the circuit of the remote transformers to no more than
the maximum rated capacity as specified.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
www.techlighting.com
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
4
847.410.4400
A Generation Brands Company
Advertisement
