Tech Lighting 700AT300TR Installation Instructions

12v single feed recessed magnetic transformer

Download this manual

Installation Instructions for

12V Single Feed Recessed Magnetic Transformer

TRANSFORMERS

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

This product may require some modification (remodeling) to

existing wall where the transformer is to be mounted. The

wall studs should be 16" apart.

A typical installation is shown. Specific installation must be

in accordance with local electrical codes.

This product is suitable for dry locations only.

This product may be dimmed only with a low voltage

magnetic dimmer. Using a dimmer not designed for low

voltage magnetic applications may work initially, but will

eventually cause transformer failure and will void the

warranty. The dimmer must be derated as indicated by the

dimmer manufacturer.

This product is intended for use with Tech Lighting low

voltage lighting systems only.

During installation, make sure all power connections are

tight.

Read all instructions thoroughly. Read "Important Safety

Information" on page 4 before proceeding with the

installation.

C AUTION — RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

920RT121C

700AT300TR

1.8

Page 1 The dimmer must be derated as indicated by the dimmer manufacturer. This product is intended for use with Tech Lighting low voltage lighting systems only. During installation, make sure all power connections are tight.
Page 2 Connect the 12 Volt Low Voltage Install the Transformer Wires BRACKET LOW VOLTAGE WIRES SCREW STUD Select the location between the studs (16" apart) where the transformer is to be mounted. Place the transformer between the studs and fasten it to the studs through the bracket holes with four #8 or #10 screws (not provided).
Page 3 11V - 12V screw. ~AC. If the voltage does not fall in this range, call Tech Lighting "Technical Support" at 847-410-4606. Insert the neutral power line wire inline with the white transformer wire into the terminal block and tighten the Operate the system for five minutes.
Page 4 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.