HP AYINE User Manual page 7

• Keep your ADF out of direct sunlight and heat sources.
• Route the power cable so that it is not likely to be walked on or pinched by
items placed on or against it. Pay particular attention to the point where the cable
attaches to the ADF.
• Only use the AC adapter included with the ADF. Using any other power adapter
will void warranty.
• Unplug the power cord from the power outlet when the unit is not in use.
Cleaning the ADF
Treat the screen gently.
To clean fingerprints or dust from the LCD screen we recommend using a soft,
non-abrasive
cloth such as a camera lens cloth. If you use a commercial LCD cleaning kit, do not
apply the cleaning fluid directly to the LCD screen. Clean the LCD screen with the
cleaning solution applied to the cleaning cloth. Clean the outer surface of the ADF
with a soft cloth dampened with water.
Safefy (FCC/CE/CCC) Statement
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located
or operating in conjunction with any other antenna or transmitter. To comply with
FCC RF exposure compliance requirements, this grant is applicable to only Mobile
Configurations. The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter.
FCC CAUTION: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COM-
PLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAU-
THORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.
7