Panasonic ES4033 Operating Instructions Manual page 7

P10-13.ES4033/4035(Asia)EN 09.10.19 16:12 ページ 12
100042628_ES4033_Asia_Tori
new inner blade, hold the blade, one
at a time, at both ends and press
downward until it snaps into the
shaver.
For environmental protec-
tion and recycling of mate-
rials
This shaver contains Nickel-Cad-
mium battery.
Please make sure that the battery is
disposed of at an officially assigned
location, if there is one in your coun-
try.
How to remove the built-in
rechargeable battery before dis-
posal of the shaver
(see fig.10)
The battery in this shaver is not
intended to be replaced by consum-
ers. However, the battery may be
replaced at an authorized service
center. The procedure described
below is intended only for removal of
the rechargeable battery for the pur-
pose of proper disposal.
1. Disconnect the adapter from the
AC outlet, and remove the power
cord from the shaver.
2. Remove the outer foil frame and
the inner blades.
3. Remove the trimmer driving bar
(a), and two screws (b).
4. Remove the screw (c) and the
bottom cover (d).
5. Remove the two screw covers (e)
(using something like a toothpick),
two screws (f), and the panel cov-
ers (g).
6. Remove the four screws (h), and
Refine_0012_ES4033_Asia.p1.pdf
Refine_12-02-14 19:49:58
the back panel (i).
bat-
7. Remove the battery from the bat-
tery block (j).
Caution
e the
• Do not charge the shaver where the
F) or
temperature is below 0°C (32°F) or
t will
above 40°C (104°F), where it will
or a
be exposed to direct sunlight or a
a lot
heat source, or where there is a lot
of moisture.
E7-19
• Use only the included adaptor RE7-19
aver.
to charge the ES4033/ES4035 shaver.
efore
• Dry the shaver completely before
charging it.
water
• Keep the adaptor away from water
ds.
and handle it only with dry hands.
nect-
• Grip the adaptor when disconnect-
g on
ing it from an AC outlet; tugging on
the power cord may damage it.
area
• Store the adaptor in a dry area
dam-
where it will be protected from dam-
age.
bend
• Do not pull, twist, or severely bend
the power cord.
ghtly
• Do not wrap the power cord tightly
around the appliance.
dled
• The outer foil is very thin. If handled
dam-
improperly, it can be easily dam-
y, do
aged. To avoid personal injury, do
dam-
not use the shaver if it has a dam-
aged foil or inner blade.
aver
• Place protective cap over shaver
head after use.
r. Do
• Wash the shaver in tap water. Do
water.
not use salt water or boiling water.
ducts
Also, do not use cleaning products
bath-
that are designed for toilets, bath-
Do
rooms or kitchen appliances. Do
long
not submerge the shaver for a long
time.
12
12
P10-13.ES4033/4035(Asia)EN 12.3.2 16:39 ページ 13
7 12-03-05 14:52:09
Refine_0013_ES4033_Asia.p1.pdf
Refine_12-03-02 16:48:08
13