Download Print this page

SNOWDOG Compact B13ME Installation Instructions Manual

Baltmotors
Hide thumbs Also See for Compact B13ME:

Advertisement

Quick Links

TRACKSLED REVERSE GEAR INSTALLATION INSTRUCTION
1
Unscrew 3 screws and take off the chain guard
casing.
2
Unzip the cover and disconnect the headlight
wire connector, bending the wire connector
latch.
BALTMOTORS
www.snowdog.com
3
Unscrew the screw which fixes the headlight
to the bracket, take off the headlight and pull
out the headlight wire.
4
Unscrew all the M6 screws which secures the
cover to the frame and take the cover off.
5
Unscrew 6 M8 screws, which mounts the
engine bracket to the frame and remove the
cover.

Advertisement

loading
Need help?

Need help?

Do you have a question about the Compact B13ME and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SNOWDOG Compact B13ME

  • Page 1 BALTMOTORS www.snowdog.com TRACKSLED REVERSE GEAR INSTALLATION INSTRUCTION Unscrew 3 screws and take off the chain guard Unscrew the screw which fixes the headlight casing. to the bracket, take off the headlight and pull out the headlight wire. Unzip the cover and disconnect the headlight wire connector, bending the wire connector latch.
  • Page 2 Move the engine bracket forward. Unscrew 4 engine-securing M8 nuts and take off 2 guide bushings. Unscrew the driven star and take off the chain. Remove the CVT belt. Unscrew 2 M6 screws and remove the chain guard. Loosen the screw, which fixes the brake cable to the brake caliper and disconnect the brake cable.
  • Page 3 Remove the cable from the parking lever. Insert 4 engine-securing screws with nuts (1) in the engine bracket. Place the engine bracket assembly with the reverse gear and CVT driven pulley on the tracksled. Insert 6 engine bracket-securing screws (2). Remove the plastic fasteners of the parking brake and wiring.
  • Page 4 Rotate the engine to set the drive CVT pulley Install the driven sprocket and the chain. parallel to the driven CVT pulley. Tighten the chain and the engine bracket- securing bolts. Tighten 4 engine-securing nuts. Place the lug of the new cable into the parking brake handle.
  • Page 5 Loosen the parking brake cable near the Lay the reverse switch cable over the frame lever completely. Make sure the lever is easy and the handlebar and secure it with plastic to press, and that the lever and the parking fasteners.
  • Page 6 Move the lever (4) all the way down and make Install the chain guard on the engine bracket sure that the forward gear is turned on by and tighten the two M6 screws. rotating the CVT driven pulley. Loosen the bolts (5) and slide the bracket (6) Put the cover on the headlight bracket.
  • Page 7 Fix the headlight to the bracket, thread the Tuck the cover under the chain guard. wire through the cover hole Secure the cover and the front mudguard with screws. Connect the headlight wire connector to the wiring connector, secure the cable to the frame with the plastic fasteners.
  • Page 8 Pull on the left side of the cover and secure it Pull on the right side of the cover and secure it with velcro. with velcro. Secure the cover with the screw behind the chain guard.
  • Page 9 Install the cover support bracket and secure it Secure the cover on the bottom right and with screws on the top left and top right sides. bottom left sides. Install the shutter between the engine compartment and the cargo compartment. Install the chain guard casing.

This manual is also suitable for:

Standard b13merStandard b13me