Approved Detergents - NEUGART HLAE Series Instruction Manual

Instruction manual Hygienic Design Planetary Gearbox
4 Description

4.5 Approved detergents

GB_ 100225294 / Rev. status "004"
During several exacting test series, the HLAE's resistance against the following industrial
detergents was tested under the toughest conditions:
Products by ECOLAB
P3-topax 19
P3-topax 12
P3-topax 990
* P3-topax 12, P3-topax 56, P3-topactive DES are usable according to the material
suitability test carried out with the respectively more aggressive medium.
Test setup:
The material suitability test has been carried out by Ecolab in accordance with test
method 40-1. During this test, the surfaces of the gearbox materials were placed into
the respective detergent at a 3% concentration at a temperature of 21°C.
After successfully passed material suitability test, the compatibility with the detergents
specified is given.
This should correspond to approx. 2500 cleaning cycles with respectively 15 minutes
contact to the detergent or approx. 1500 cleaning cycles with cleaning and subsequent
disinfection.
Neugart can only provide a guarantee for the gearbox service life if the tested
detergents are used. Other detergents than the ones mentioned can be tested and
where appropriate approved by Neugart on request.
P3-topax 52
P3-topax 56
P3- topactive OKTO
P3-topactive DES *
P3-topax 66
12