Table of Contents
Advertisement
Vector VIP System User's Manual
the platen axle, press on the metallic levers on each side of the form feed
tractor.
In order to use a form-feed tractor, the platen pressure lever on the
right side of the Sprint 3 or Sprint 5 printer must be in the forward position
so
that the paper slides through freely.
3) Once the VIP System and its printer are tested and working, you have
completed the basic installation and check out.
You may proceed to (1) make
the necessary modifications for the Memorite word processing software (also
called the Word Management System), (2) install additional terminals, (3)
install graphics hardware and software, (4) connect and test a modem or
acoustic coupler, or
(5)
make use of the other software which comes with the
system.
To do
(1),
refer to the instructions that come with the Merrorite software.
TO do (2), refer to the instructions which
come
with the Time-Share Multi-User
System
B
conversion package.
To do
(3),
refer to the appropriate technical
manuals for graphics-related boards and software.
'Ib
do
(4)
(connect a modem
or acoustic coupler), contact Vector Graphic.
For
(5),
refer to the manuals
for that software.
After all interior modifications are complete, you may screw down the
computer cover.
4.3 Installing and using the Sprint 3 printer
This section is only applicable if the internal interface components of the
Sprint 3 Subsystem have already been installed within the computer chassis.
4.3.1
Unpacking
1. If not already done, rerrove the printer from its carton and any plastic bag.
The following items should be found in the carton: Sprint 3 printer, special
power cable (a thick round cable with a 12-pin molex connector at one end),
4 round metal plugs, a printwheel, and a ribbon.
2. Inspect the printer for scratches, dents, loose or damaged parts, or other
signs of damage.
N::>te any evidence of such damage on the invoice, and file
a claim with the carrier immediately, if the condition of the units
warrants.
3. Using a 7/16-inch (or 11
rnm)
socket wrench, rerrove the four screws securing
the printer to its shipping pallet.
4. Insert the 4 round metal plugs in the holes vacated by the pallet screws on
the bottom of the printer.
5. :Remove any paper wrapped around the platten.
6. Remove the top front cover by lifting up under the edge at the front of the
printer.
Rev.
A
8/27/80
4-3
Advertisement
Table of Contents
