Setup - easyteck T110 Manual

2. SETUP

• Place your phone on flat surface with screen facing down; remove back cover by
sliding it upwards.
• Locate the SIM card slot and insert the card-metal contacts are pointing downwards.
• If you want to, you can also insert a microSDHC card. Lock it by shifting the metal
slider to LOCK position.
• Insert battery.
• Put the back cover on its original place.
Charging battery
• Make sure the battery is inserted.
• It's possible to charge this phone both in on and off states.
• Charger connector is located on the bottom side of the phone.
• it's also possible to charge this phone directly over included 230 V charger with a
microUSB connector or by placing it in stand and then connecting the stand to the
charger. Once the battery is fully charged, disconnect the charger from the wall outlet.
14
Turning on/off
In order to turn the phone on, hold the button with a red telephone receiver symbol on it (9)
until the phone turns on.
Input SIM card pin code, in case it's required.
In order to turn the phone off, hold the button with a red telephone receiver symbol on it (9)
until the phone turns off.
Keypad lock
In order to lock the keypad slide the keypad lock switch, which is located on the side of the
phone, down.
In order to unlock the keypad slide it back up.
Phone lock password is used in order to prevent other people from using your phone. It's
usually set up by the phone manufacturer and it can be changed later.
This password is set to 1122 by default for this particular device.
In case the phone is locked, it's not possible to use it until you input the correct password. In
case you change the default factory password setting, make sure to properly note the new
one!
15