TECHLIGHTING Revel Pathway Installation Instructions page 3

3C
CONNECTION
BOX COVER
DOME NUT
CONNECTION
BOX COVER
9
SCREW
Feed the previously installed power wires / cord through
6
the cord grip and dome nut, then screw the dome nut
tightly onto the cord grip.
7 Connect the white driver wire to one of the low-voltage
power line wire with a wire nut.
Connect the black fixture wire to the remaining low-
8
voltage power line with a wire nut.
Carefully place all wires and wire nut connections into
9
the connection box and reinstall the cover (reversal of
step 3).
3D
Caulk around the power line/cord where it enters the
10
cord grip with waterproof construction sealant.
7
8
CORD GRIP
6
POWER WIRES/
CORD
3E
11
Carefully place the power line/cord inside the fixture,
11
install the fixture onto the base plate, and secure it in
place by tightening down the set screws.
3
SET SCREW
11
ALLEN
WRENCH