Page 2
Storing a movement position The IMSG 230 can store the movement position of the connected drive. The position stored (e.g. a frequently used position for a shutter or partial opening of window) can be recalled by pressing the down button for a longer time (3-6 seconds).
Page 3
• As feedback the drive briefly moves up and down. The storage is complete and the IMSG 230 is in normal mode again. Note: As soon as a central command arrives (e.g. because of a wind or rain alarm), the programming mode is interrupted! In this case, please carry out the position storage again when the central command is no longer present.
Page 4
Elsner Elektronik is not liable for any changes in norms and standards which may occur after publication of these operating instructions.
Installation and start-up 4.2. Connection diagram Power supply and central input: Mains Central Drive and push-button input: Button Motor control unit IMSG230 • Version: 05.02.2016 • Technical Changes and Errors excepted.
Page 6
Installation and start-up 4.3. Example of the structure of a simple central control unit CENTRAL UNIT (e.g. timer, central switch or automatic controller) Units such as the Solexa shading control or Arexa window control are suitable for use as central control units. 4.4.
Page 7
Installation and start-up If multiple power supply lines are used, cut-off relays must, as required, also be used. 4.5. Notes on mounting and commissioning Device must not be exposed to water (rain). This could result in the electronic being damaged. A relative air humidity of 95% must not be exceeded. Avoid bedewing. Pay attention to the correct connection.
Need help?
Do you have a question about the IMSG 230 and is the answer not in the manual?
Questions and answers