Vaxcel T0102 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0101 / T0102
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Mounting Screw (A) Mounting Screw (B)
Note: Fixture can be wall mounted or eave mounted.
Wall Mounted
Light fixture should be mounted as shown above when installed (depending upon type of installation)
Wire Nut (H)
Outlet Box
Mounting Strap (E)
IMPORTANT:
The fixture features a photocell sensor which enables the light to turn on at dusk and off at dawn automatically.
Turn off the power at fuse or circuit box.
1. The mounting bracket is pre-assembled on the light fixture, unscrew the decorative cover, fixture mounting screw and
remove the mounting bracket.
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Mounting Screw (C) Mounting Bracket Screw (D)
FRONT
T0101 / T0102 --- Page 1 / 2
Mounting Strap (E)
Decorative Cover(F)
Eave Mounted
Mounting Bracket
Mounting Bracket Screw (D)
Back Plate
Light Head
Decorative cover (F)
Fixture Mounting Screw (G)
Wire Nut (H)
140919