Before Use; Installation - Prem-I-Air EH1566 Manual

These instructions should be read carefully and left with the user of the product
for future reference.
You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.
The EH1566 must be wall-mounted. Remove the mounting bracket from the
back of the heater. Decide upon the position of the heater, so that it is at least 50
mm (2") clear of any object to the sides and 150 mm (6") from the floor. If the
EH1566 is fitted below a shelf, ensure that there is 700 mm (27") clearance
between the top of the heater and the shelf. Using the bracket as a template, and
using a spirit level to makes sure that the bracket is fitted level, drill two holes in
the wall. Insert a wall-plug into each hole. Fix the bracket to the wall with the four
screws supplied.
When used in a workplace, this product must be safety-tested yearly by a
qualified electrician (PAT Tested) in order to comply with the Electricity at Work
Regulations.
We recommend that it is PAT tested regularly when used in a domestic
environment.
IMPORTANT
Installer and Users please note:

BEFORE USE

INSTALLATION

PAT TESTING
Then hang the heater on the bracket and
secure with the screw at the top right hand
side.
It is recommended that the EH1566 be
connected to the mains supply via a fused
spur, although a 13 A plug and socket may
be used.
2