Advertisement
© 2015 Edge Lighting. All Rights Reserved.
Installation Instructions for
IMPORTANT INFORMATION
- This product is ETL listed for indoor dry locations.
SAVE THESE INSTRUCTIONS!
Install the Accessory Shade in Chopper type Fixtures
A
LOUVER
HOLDER CAP
2: Place the MR16 lamp into the louver holder base.
3: Place a hexcell louver (Optional) or a glass lens (Optional) or
a combination of a hexcell louver and a glass lens on the
front of MR16 lamp.
4: Replace and tighten the louver holder cap to the louver
holder base.
C
SOCKET
Solid Back Shade MR16
LOUVER
HOLDER BASE
1
MR16 LAMP
ACCESSORY SHADE
5
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
info@edgelighting.com
1: Unscrew and remove the louver holder cap from the louver
holder base.
B
LOUVER HOLDER CAP
5: Push the lamp pins completely into the socket holes.
S6-_
MR16 LAMP
3
2
4
HEXCELL LOUVER
LOUVER HOLDER BASE
OR GLASS LENS
904-S6-03
1
Advertisement
Table of Contents
Related Manuals for Edge Lighting Solid Back Shade MR16
Summary of Contents for Edge Lighting Solid Back Shade MR16
-
Page 1: Important Information
S6-_ Chicago, IL 60614 Tel: 773-770-1195 Fax: 773-935-5613 www.edgelighting.com info@edgelighting.com © 2015 Edge Lighting. All Rights Reserved. Solid Back Shade MR16 Installation Instructions for IMPORTANT INFORMATION - This product is ETL listed for indoor dry locations. SAVE THESE INSTRUCTIONS! Install the Accessory Shade in Chopper type Fixtures 1: Unscrew and remove the louver holder cap from the louver holder base. - Page 2 Install the Accessory shade in Vespa type MR16 Sockets 1: Push the spring clip completely onto the center of the socket groove until it snaps into place. SOCKET SHADE SPRING CLIP HEAD SOCKET 2: Squeeze the spring clip ends while inserting it into the shade.
Need help?
Do you have a question about the Solid Back Shade MR16 and is the answer not in the manual?
Questions and answers