Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Kallista P24408
Summary of Contents for Kallista P24408
- Page 1 Installation Guide Floor-Mount Bath Faucet P24408 1156618-2-B...
- Page 2 Installer-supplied copper tubing must be 5/8″ OD (1/2″ nominal). Carefully review this document and any appropriate Roughing-in documents. Design the bath enclosure accordingly. The appearance of your faucet may differ from the illustrations in this guide. The instructions still apply. 1156618-2-B Kallista...
-
Page 3: Prepare The Site
6" (152 mm) Min Width 1. Prepare the Site NOTICE: Adequate floor support is required. The wood support must be a minimum of 2″ (51 mm) thick by 6″ (152 mm) wide. 2x6 lumber is NOT adequate for this application. Kallista 1156618-2-B... - Page 4 The cold supply should be connected where the blue mark or the notch is located. Test the handle to verify full rotation will not interfere with the bathing fixture or the back wall. 1156618-2-B Kallista...
-
Page 5: Install The Base
Drill 1-1/2″ (38 mm) deep holes with a 3/16″ drill bit (provided) using the marked locations as the center point. Secure the base to the support with the screws and washers provided. Verify the base is level and tighten the screws. Kallista 1156618-2-B... - Page 6 NOTE: The base has a blue mark and a notch on the cold supply side. Insert the plug into the base. Turn on the main water supply and check for leaks. Turn off the main water supply. Secure the guard onto the base with the screws provided. 1156618-2-B Kallista...
- Page 7 Guard Finished Floor Ø 3" (76 mm) 5. Install the Finished Floor Finish the floor leaving a 3″ (76 mm) diameter hole for the guard. Cut the guard so it is flush with the finished flooring. Kallista 1156618-2-B...
-
Page 8: Install The Faucet
Remove the plug from the base. Remove the rubber protector (not shown) from the faucet. Place the faucet onto the base and insert the screws and washers provided through the flange. Tighten the screws using the hex wrench provided. 1156618-2-B Kallista... - Page 9 Install the washer and hose onto the check valve assembly. Insert the screen washer into the end of the hose and install the handshower to the hose. Place the handshower into the handshower holder. Kallista 1156618-2-B...
-
Page 10: Installation Checkout
Point the hose into the bath and turn the faucet handle to the ON position. Run hot and cold water through the hose to remove debris. Check for leaks. Turn the faucet off. Reinstall the handshower to the hose. Place the handshower into the handshower holder. 1156618-2-B Kallista... - Page 11 1156618-2-...
- Page 12 USA/Canada: 1-888-4-KALLISTA Fax: 1-888-272-3094 kallista.com ©2013 KALLISTA 1156618-2-B...
Need help?
Do you have a question about the P24408 and is the answer not in the manual?
Questions and answers