Advertisement
- Check the function before mounting.
- Drill a hole (Ø 3,5 mm) at the mounting place (see fig. 1).
- Put the cables from outside through the hole and push the
socket into the hole (see fig. 2).
Caution:
Never touch the mast but only the patented base socket (fig. 3).
When connecting the cables, please leave ca. 2 – 3 cm behind
the lamp to create a loop, which enables you to pull the lamp
out of the assembly drilling.
5. Connection
Caution:
Resistor and diode at the cables are required for proper
function of the lamp (fig.4). Never cut them off!
Never cover resistor or diode with insulation material,
because they have to be cooled by surrounding air!
Connect the LED-lamp to the light output of a model train
transformer (e. g. item-No. 5200) as shown in fig. 4 and/or 5.
DC voltage: Connect the diode with the positive pole and the
resistor with the negative pole of the power supply.
AC voltage: Operation with AC voltage could cause some
flickering. We recommend to use the Viessmann power
module item-No. 5215 (fig. 5) which is sufficient for approx.
100 LED-lamps or reflectors. Connect the cable with the diode
to the brown output socket and the cable with the resistor to
the red output socket (fig. 4).
6
Notizen
Notice
7
Advertisement
