Table of Contents
Advertisement
SAFETY AND PRECAUTION
1
Consider the work area environment. Do not expose the tool to rain. Do not
use the tool in damp or wet locations – Keep work area clean and well lit. Do
not use the tool in the present of flammable liquids or gases.
2
Guard against electric shock. Avoid body contact with earthed or grounded
surfaces.
3
Keep children away. Do not let visitors touch the tool. All visitors should be
kept away from work area.
4
When not in use, the tool should be stored in a dry locked up place, out of
reach of children.
5
Do not force the tool. It will do the job better and safer at the rate for which
it was intended.
6
Stay alert. Watch out what you are doing–Use common sense. Do not oper-
ate tool when you are tired. Check damaged parts. Before further use of the
tool, if a guard or other part is damaged it should be carefully checked to
determine that it will operate properly and perform its intended function.
7
Check for alignment of moving parts, blinding of moving parts, breakage of
parts, mounting and any other condition that may affect its operation.
8
A guard or other parts that is damaged should be properly repaired or
replaced by an authorized service center unless otherwise indicated in this in-
struction manual. Have defective switches replaced by an authorized service
center. Do not use the tool if switch does not turn it on.
9
To ensure the designed operational integrity of power tools, do not remove
installed cover or screws.
10 Use your tool at lower input than specified on the nameplate, otherwise, the
finish may be spoiled and working efficiency reduced by motor overload.
11 Do not wipe plastic parts with solvent. Solvents such as gasoline, thinner,
benzene, carbon tetrachloride, alcohol, ammonia and oil containing chloric
annex may damage and crack plastic parts. Wipe plastic parts with a soft
cloth lightly dampened with soap water.
12 Dress properly. Do not wear loose clothing or jewellery. Keep your hair,
clothing, and gloves away from moving parts.
13 Use safety equipment. Always wear eye protection, non-skid safety shoes,
and hearing protection.
14 Do not overreach. Proper footing and balance enables better control of the
tool in unexpected situations.
2
Advertisement
Table of Contents
