Advertisement
Start by using your
template on the left
side of your window
to mark the holes of
your hood and side
arms. Once you
have marked the
holes, pre drill them
and insert the wall
plugs.
Now insert the top
hood tab screw, but
do not fully tighten
the screw and hang
the awning on this
screw. This will allow
you to then mark
the opposite hood
tab holes. Ensure
that your hood is
level by using a
spirit level prior to
marking out. Take
the hood down.
Take your template
and mark the
remaining screw
holes including your
side arms.
Pre- drill your holes,
ensuring that the
holes are deep
enough and insert
wall plugs provided.
Insert your top hood
screw and hang your
hood. Now insert
each of your four
hood screws. Finally
tighten each of the
four screws, to finish
mounting your
awning hood
Advertisement
