Page 1
MUA Filter Pressure Sensor FPS Installation Guide This document is applicable to BBCB-A-1-1 Make-Up Air Controllers. This document will take you through the upgrade to include the filter delta P sensor. A pressure sensor is used to determine the “dirtiness” (or pressure drop) of the Make-Up Air Unit Filters.
Page 2
MUA Filter Pressure Sensor FPS Installation Guide Open the access cover plate, by loosening the four screws and sliding the panel sideways (use a flat blade (or hex) screwdriver). Install the two screws from behind using two nuts (supplied) and tighten them (see above, View A-A).
Page 3
MUA Filter Pressure Sensor FPS Installation Guide The screen should look like this: If you purchased the standard MUA unit select the “basic-filter.conf” and press the “submit” button. If you purchased the Heating Assist Unit select the “attic-filter.config”and press the “submit” button. Confirm your choice is loaded properly, see “current config”...