Vigia NM 343 User Manual page 10

Explanation: If the equipment is
in manual mode and there is an air
loss in any of the pressures, it auto-
matically goes to sequential mode.
Excessive Loss of Pressure
When there is low air pressure in the deposit (less then 80 PSI), the
equipment will deactivate automatically and it will indicate the inlet
pressure P warning the driver with 3 beeps every 2 seconds.
Explanation: If there is a pressure calibrating, it indicates
sequentially P and the pressure at issue (1, 2 or 3).
Cancellation
If you wish to deactivate a pressure, proceed as following:
- Configure to manual mode pressing
or for 3 seconds.
- Select the pressure you want to
deactivate using
- Press (confirmation with 1 beep
and the number of the pressure will blink
indicating that it has been deactivated).
To activate that pressure again follow the
three steps mentioned or close and open
the contact key.
or .
8
10 SECONDS
120 140
160
100
PSI
9 10
80 8
7 11
6 BAR
60 5
4
BAR
PSI
40 3
PSI BAR
120 120 140 140
160 160
100 100
PSI PSI
9 10 9 10
80 80 8 8
7 7 11 11
6 6 BAR BAR
60 60 5 5
4 4
BAR BAR
PSI PSI
40 40 3 3
BAR BAR
PSI PSI
3 SECONDS
120 120 140 140
160 160
100 100
PSI PSI
9 10 9 10
80 80 8 8
7 7 11 11
6 6 BAR BAR
60 60 5 5
4 4
BAR BAR
PSI PSI
40 40 3 3
PSI PSI BAR BAR
120 120 140 140
100 100 160 160
PSI PSI
9 10 9 10
80 80 8 8
7 7 11 11
BAR BAR
6 6
60 60 5 5
4 4
BAR BAR
PSI PSI
40 40 3 3
PSI PSI BAR BAR
BLINKING