Philips HP4640/00 User Manual page 7

Preparing for use
1 Unscrew the Cool Tip water reservoir from the brush (fig. 1).
2 Fill the reservoir with water to the maximum level indication
under a gently running tap (fig. 2).
3 Hold the appliance vertically with the brush end pointing
downwards, and screw the reservoir back onto the brush (fig. 3).
4 Unscrew the reservoir a quarter turn and tighten it again to
ensure proper fastening and to prevent leakage.
Using the appliance
Before styling, comb or brush your hair so that it is completely
B
untangled and smooth.
We advise you to perform a curl test to determine how long the brush
B
should be held in your hair to achieve a good result. Start with 8 to 10
seconds.You may have to hold the brush in your hair longer for tighter
curls. Less tight curls will require less than 8 seconds.
1 Insert the mains plug into the wall socket (fig. 4).
The pilot light goes on and the appliance starts heating up.
The appliance is ready for use after approx. 15 minutes.
2 Start styling when the ready dot on the attachment changes
colour (fig. 5).
3 Take a lock of hair and wind it round the brush. Make sure the
end of the lock is wound in the required direction (fig. 6).
Do not wind too much hair round the barrel at a time.
The thinner the lock of hair, the tigher the curl will be.
Do not wind a lock of hair more than twice round the brush.
Make sure the lock of hair is in contact with the barrel of the brush.
4 Activate the steam function by pushing the Cool Tip water
reservoir into the barrel. Keep it pressed in for up to 3 seconds
before releasing it (fig. 7).
ENGLISH
7