Section 6 - Service; Door Removal - Manitowoc Q Series Installation, Use, Care, And Service Manual

Section 6

Door Removal

Before removing any parts, unplug or disconnect
the electric power to the dispenser at the electric
service switch box.
1. Shut off the water if applicable.
2. Loosen the two access screws located on the sides
of the front panel, above the catch basin.
3. Lift up and pull forward on the top of the door
until the upper door retainers disengage.
4. Pivot the door 90°. This should provide adequate
access. If complete door removal is desired,
perform steps 5-8.
5. Disconnect the water supply line at the water
delivery spout quick disconnect if applicable.
6. Disconnect the push button switch wiring by
removing the female push-on terminals at the
switch.
7. Remove the door.
WARNING
Section 6
Service
ACCESS
SCREWS
Door Removal
Service
SV1660GM
6-1