Advertisement
EnGlISH
Introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from the
support that Philips offers, register your product at www.philips.com/welcome.
This TRESemmé Philips appliance is designed and created to give you the salon styles
you want, in a quick and easy way. We hope you enjoy using this TRESemmé Philips
styler.
General description (Fig. 1)
A Cool tip
B
Clip
C Lever
D Handle
E
Hanging loop
F
Barrel
G Support
H Display
I
Temperature decrease/lock button
J
Temperature increase button
K
On/off slide
Important
Read this user manual carefully before you use the appliance and save it for future
reference.
Danger
-
Keep the appliance away from water. Do not use it near or over water contained
in baths, washbasins, sinks etc. When you use the appliance in a bathroom, unplug
it after use. The proximity of water presents a risk, even when the appliance is
switched off.
Warning
-
Check if the voltage indicated on the appliance corresponds to the local mains
voltage before you connect the appliance.
-
Check the condition of the mains cord regularly. Do not use the appliance if the
plug, the mains cord or the appliance itself is damaged.
-
If the mains cord is damaged, you must have it replaced by Philips, a service
centre authorised by Philips or similarly qualified persons in order to avoid a
hazard.
-
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
-
Children should be supervised to ensure that they do not play with the
appliance.
-
Keep the appliance away from non-heat-resistant surfaces and never cover the
appliance with anything (e.g. a towel or clothing) when it is hot.
-
Keep the appliance away from flammable items.
-
Never leave the appliance unattended when it is connected to the mains.
Caution
-
For additional protection, we advise you to install a residual current device
(RCD) in the electrical circuit that supplies the bathroom. This RCD must have
a rated residual operating current not higher than 30mA. Ask your installer for
advice.
-
The barrel and the clip become hot during use. Prevent the hot surfaces of the
appliance from coming into contact with your skin.
-
The maximum temperature occurs just after heating up. The actual temperature
during use may be lower.
-
Always unplug the appliance after use.
-
For safety reasons, the appliance automatically switches off after having been on
for 1 hour.
-
Wait until the appliance has cooled down before you store it.
-
Always switch off the appliance before you put it down, even if it is only for a
moment.
-
Do not leave the barrel in your hair for more than a few seconds at a time to
prevent damage to your hair.
-
Do not wind the mains cord round the appliance.
-
Only use the appliance on dry hair.
-
Do not use the appliance on artificial hair.
-
Do not use the appliance for any other purpose than described in this manual.
-
Keep the barrel and the clip clean and free of dust, dirt and styling products such
as mousse, spray and gel. Dust, dirt and styling products may cause damage to
the ceramic coating.
-
The barrel and the clip have a ceramic coating. This coating slowly wears away
over time. This does not affect the performance of the appliance.
-
If you use the appliance on colour-treated hair, the barrel may stain.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields
(EMF). If handled properly and according to the instructions in this user manual, the
appliance is safe to use based on scientific evidence available today.
Using the appliance
Curlers are powerful styling tools and must always be used with care.
As with all curlers that reach salon high temperatures, do not use the appliance
frequently to avoid damage to the hair. If you use the curler incorrectly or if you use it
at the wrong temperature setting, you could overheat your hair or even burn it.
F
G
H
I
J
K
2
6
10
14
Curling
1
Put the plug in the wall socket.
2
Set the on/off slide to 'I' to switch on the appliance. (Fig. 2)
The default temperature setting of 120 appears on the display. (Fig. 3)
,
As soon as the appliance has heated up to this setting, the word 'READY'
,
appears on the display.
Never leave the appliance unattended when it is plugged in. Always put the
appliance on a heat-resistant surface when it is heating up and when it is hot.
3
Select a temperature setting that is suitable for your hair type.
-
Always select a low setting when you use the curler for the first time.
-
For thick or coarse hair, select a medium to high setting (170 and up).
-
For fine or normal hair, select a medium to low setting (160 and below).
Take extra care with pale, blonde, bleached or colour-treated hair, since it is
susceptible to damage at high temperature settings.
4
Press the + button to increase the temperature setting or the - button to
decrease the temperature setting (Fig. 4).
The display shows the selected temperature setting.
,
As soon as the appliance has heated up to the set temperature setting, the
,
word 'READY' appears on the display. (Fig. 5)
5
If you want to lock the set temperature setting, press and hold the
temperature decrease/lock button for a few seconds (see section
'Temperature lock').
6
Divide your hair into locks and put them aside with clips. (Fig. 6)
Note: The thinner the lock of hair, the tighter the curl becomes.
7
Start curling at the lower part of your head and work your way up to the
crown.
8
Take the lock of hair you want to curl and comb it first, to get rid of
tangles (Fig. 7)
9
Press the lever to open the clip. Place the lock of hair between the barrel and
the clip (Fig. 8).
A
B
C
D
E
3
4
7
8
11
12
1
5
9
13
Advertisement
