User Information; Thermostat Settings; Warnings For Temperature Settings - Bush BUCL6082 Installation & User's Instructions

Built in larder
Hide thumbs Also See for BUCL6082:
Table of Contents

Advertisement

USER INFORMATION

Thermostat settings

The thermostat automatically regulates the
inside temperature of the larder. By rotating the
knob from positions 1 to 5, colder temperatures
can be obtained.
Important note: Do not try to rotate knob
beyond 1 position it will stop your appliance
• For the short-term storage of food, set the
larder knob between the minimum and
medium position (1-3).
• For the long-term storage of food, set the
larder knob to the medium position (3-4).
• Note that the ambient temperature (temperature
of the freshly stored food and how often the
door is opened) affects the temperature in
the larder if required, change the temperature
setting.
• When you first switch on the appliance, you
should ideally run it without any food for 24
hours and not open the door. If you need to
use it straight away, try not to put too much
food inside.
• If the unit is switched off or unplugged, you
must allow at least 5 minutes before restarting
to avoid damaging the compressor.
16
Customer Helpline: 0345 257 7271

Warnings for temperature settings

• The ambient temperature, temperature of the
freshly stored food and how often the door is
opened, affects the temperature in the fridge.
If required, change the temperature setting.
• It is not recommended that you operate your
fridge in environments colder than 10
terms of its efficiency.
• The thermostat setting should be done
by taking into consideration how often the
fresh food door is opened and closed, how
much food is stored in the fridge, and the
environment in which the fridge is located.
• Your fridge should be operated up to 24
hours according to the ambient temperature
without interruption after being plugged in to
be completely cooled. Do not open doors of
your fridge frequently and do not place much
food inside it in this period.
• A 5 minute delaying function is applied to
prevent damage to the compressor of your
fridge, when you take the plug off and then
plug it on again to operate it or when an energy
breakdown occurs. Your fridge will start to
operate normally after 5 minutes.
• Your fridge is designed to operate in the
ambient temperature intervals stated in the
standards, according to the climate class
stated in the information label. It is not
recommended that your fridge is operated in
the environments which are out of the stated
temperature intervals in terms of cooling
efficiency.
Climate Class
Ambient Temperature
Between 16 and 43 (
T
Between 16 and 38 (
ST
Between 16 and 32 (
N
Between 10 and 32 (
SN
C in
o
C
o
C)
o
C)
o
C)
o
C)
o

Advertisement

Table of Contents
loading

Table of Contents