Troubleshooting - Clatronic EKI 3092 Instruction Manual

CL_BDA_IKP_3092_NEU_ka3.qxd
Ceramic Hob
GB
• Clean the surface from food remains when it's still warm using a moist cloth or tissue.
• Wash the hob using a soft sponge and some water, then wipe dry with a soft cloth.
• Cleaning agent for glass-ceramics surfaces: In case of stubborn, baked-in remains,
use suitable cleaning products available at special departments of department stores.
Housing
• Clean the housing after use using a slightly moist cloth.
• Make sure that no fluid matter gets into any of the openings of the housing. This might
damage the device or result in an electric shock.
• Device does not function, no indication on the display.
Remedy:
• There is a sound after I have selected a cooking function and switched the device
on.
Possible cause:
Remedy:
• The hob suddenly switches off during operation.
Possible cause:
Remedy:
Further cause:
Remedy:
• When keeping food warm the pot is not maintaining the temperature.
Possible cause:
Remedy:
• Error messages
During the operation the display shows the following security instructions:
Security instruction
E1 o. E2
E3 o. E4
E5
E6
50
15.03.2007 10:17 Uhr

Troubleshooting

Check the mains connection.
You put no or an unsuitable pot on the hob.
For reasons of safety, the device automatically switches to the
standby mode after a few seconds.
Put a pot on the hob that is suitable for induction hobs.
The overheating protection (cutout switch) has been activated.
Pull the plug and let the device cool down for about 20 min.
Then start operating the device again.
The ventilation slots are obstructed.
Free the ventilation slots from any obstructions.
The pot's base is not level or bended (convex/concave).
Put a suitable pot on the hob.
In this case, there is a problem with the electronic control.
Send the device including a description of the error to our
service centre.
Overheating. See below remedy of the fault.
Undervoltage. Check the power supply system!
Overvoltage. Check the power supply system!
Seite 50