Installation Instructions Heat Exchanger Replacement For a Shorter Heat Exchanger Replacement Models Y*C072A**(L/X) YSC072E**(M/Y) YSC(090/092)A**(L/X) YSC072E**(L/X) Y*C072A**(H/Z) YSC(090/092)A**(M/Y) Y*C072A**(M/Y) YSC072E**(H/Z) YSC(090/092)A**(H/Z) SAFETY WARNING Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training.
Page 2
Introduction Read this manual thoroughly before operating or servicing this unit. WARNING Proper Field Wiring and Grounding Warnings, Cautions, and Notices Required! Safety advisories appear throughout this manual as Failure to follow code could result in death or serious required. Your personal safety and the proper operation of injury.
Page 3
Introduction WARNING Hazardous Voltage and Gas! Failure to turn off gas or disconnect power before servicing could result in an explosion or electrocution which could result in death or serious injury. Turn off the gas supply and disconnect all electric power, including remote disconnects, before servicing the unit.
General Information Model Number Description All products are identified by a multiple-character model number that precisely identifies a particular type of unit. Its use will enable the owner/operator, installing contractors, and service engineers to define the operation, specific components, and other options for any specific unit. When ordering replacement parts or requesting service, be sure to refer to the specific model number and serial number printed on the unit nameplate.
Replacement Procedure Figure 1. WARNING Hazardous Voltage and Gas! Failure to turn off gas or disconnect power before servicing could result in an explosion or electrocution which could result in death or serious injury. Turn off the gas supply and disconnect all electric power, including remote disconnects, before servicing the unit.
Page 6
Replacement Procedure 22. Remove the belt. Figure 3. 23. Remove the indoor blower motor assembly. 24. Remove the motor mounting plate and the side wall cover. Note: The side wall cover will have to pivot from the top because copper tubing will be routed from the condensing section to the evaporator.
Page 7
Replacement Procedure create a hole to secure the rod to the divider with the the unit. Make sure that the heat exchanger catches the previously removed #10-16 x 1/2 in. sheet metal screw. support rod between the bottom primary tube and the tube directly above it.
Page 8
Trane optimizes the performance of homes and buildings around the world. A business of Ingersoll Rand, the leader in creating and sustaining safe, comfortable and energy efficient environments, Trane offers a broad portfolio of advanced controls and HVAC systems, comprehensive building services, and parts. For more information, visit www.Trane.com. Trane has a policy of continuous product and product data improvement and reserves the right to change design and specifications without notice.
This manual is also suitable for:
Trane y c072a seriesTrane ysc090a l seriesTrane ysc072e y seriesTrane ysc090a x seriesTrane ysc 092a x seriesTrane ysc072e l series...
Show all
Trane ysc072e x seriesTrane ysc092a m seriesTrane ysc090a m seriesTrane ysc090a y seriesTrane ysc 092a l seriesTrane ysc092a y seriesTrane ysc072e h seriesTrane ysc072e z seriesTrane ysc090a h seriesTrane ysc092a h seriesTrane ysc092a z seriesTrane ysc090a z series
Need help?
Do you have a question about the Trane YSC072E M Series and is the answer not in the manual?
Questions and answers