Advertisement
To delete fingerprints from memory or to set a new Administrator fingerprint, the lock must first be reset.
TSA007 lock
cylinder
1. Press the fingerprint pad until the
micro-USB
light flashes RED. It is now ready
Charging interface
to identify the active administrator
fingerprint.
• T he RED light will flash for 5
TSA007 lock
seconds. If there is no activity, the
cylinder
lock will go into standby mode.
micro-USB
Charging interface
• Clean Secure Touch Lock with a clean, dry cloth as needed
• Lubricate moving parts with standard consumer lubricant as needed
• Please only use the included USB-C charge cable to charge lock. Recommended charger output: DC5V 450mA
Light will display
GREEN
• Stop using lock if it starts smoking, is overheated, discolored, or deformed
• Do not use the lock in a violent manner
• If lock is left unused for a period of time, battery will drain and must be recharged
• Do not use if lock is thoroughly wet; electric shock can occur
• Children must use this lock with parental guidance. Recommended for Ages 14+
• If your padlock starts acting abnormally, try resetting: use any registered fingerprint (user or administrator) on the sensor,
then press the setting button after the red light turns off
• See www.Pro-4Tactical.com for Warranty and Replacement Information
CALIFORNIA PROP 65 WARNING: This product can expose you to chemicals including Benzene and Ethylbenzene which are known
to the State of California to cause cancer. For more information, go to www.p65Warnings.ca.gov
DELETING FINGERPRINTS
2. Press the administrator
setting button
fingerprint on to the
fingerprint pad.
setting button
TSA LOCK ACCESS
Every TSA-approved lock has a manual mode, which can only be used by the
Transportation Security Administration (TSA). The manual access mode is provided
so the TSA can access locked items, if necessary.
Only TSA employees are authorized to access the manual mode of the Secure
Touch Lock.
MAINTENANCE
while charging, and will turn off when complete
2.Press the setting button after the red light is out.
TROUBLESHOOTING
2.Press the setting button after the red light is out.
WARNING
If the lock has been
successfully reset, the
RED
light will display
followed by a long beep,
then go into standby mode.
If the lock has not been
successfully reset, the
light will flash
RED
followed by 4 beeps, then
go into standby mode.
Advertisement
