Download Print this page

Pro-4 Tactical Secure Touch Lock Instruction Manual page 3

2.4” fingerprint cable lock

Advertisement

TSA007 lock
cylinder
micro-USB
Charging interface
1. Press on the fingerprint pad for 3
seconds. The lock will alternate
TSA007 lock
between solid
BLUE
cylinder
waiting for an administrator fingerprint.
micro-USB
Charging interface
setting button
micro-USB
3. Place the new user fingerprint on the pad.
BLUE
The
light will turn off with a beep,
then turn on again. Repeat this process 9
more times.
setting button
micro-USB
Lock shackle
Fingerprint
setting button
sensor
1. Place a registered
fingerprint on the
fingerprint pad.
setting button
TSA007 lock
cylinder
micro-USB
Charging interface
2.Press the setting button after the red light is out.
REGISTERING USER FINGERPRINTS
Up to 9 "User" fingerprints can be stored in the Secure Touch Lock's memory.
setting button
2. Place the
administrator
and
RED
light
fingerprint on the
fingerprint pad.
setting button
UNLOCKING THE CABLE
TSA007 lock
cylinder
micro-USB
Charging interface
2.Press the setting button after the red light is out.
LOCKING THE CABLE
2.Press the setting button after the red light is out.
1. To lock the cable
wire, insert the cable
wire joint into the
locking hole.
setting button
If the light displays solid
BLUE
followed by 2 beeps,
the lock is unlocked and the
cable can be removed.
setting button
RED
If the light displays
followed
by 4 beeps, the fingerprint failed
to unlock and will go into standby
mode.
If the light displays solid
a beep, the lock is ready to register
a new user fingerprint.
If the light alternates
with 4 beeps, new user registration
has failed; please try again. If the
administrator fingerprint fails 5 times,
the lock goes into standby mode.
If the light displays solid
by a long beep, then goes into standby
mode, the fingerprint has successfully
been entered.
If the fingerprint entry has failed, or if lock
is full, the light will display
by 4 beeps, then go into standby mode.
If the cable was successfully locked, the
lock will go into standby mode.
BLUE
with
BLUE
and
RED
BLUE
followed
RED
followed
2. Remove the
steel cable
wire from the
locking hole.

Advertisement

loading