Table of Contents
Advertisement
Always remove battery pack from your tool when you are assembling
parts, making adjustments, cleaning, or when not in use. Removing
battery pack will prevent accidental starting that could cause serious
personal injury.
OPERATING
NEVER COVER THE AIR VENTS SINCE THEY MUST ALWAYS
BE OPEN FOR PROPER MOTOR COOLING.
STARTING
For accurate cutting, hold the tool at right angles to the work.
Hold the base of the tool in firm contact with the work.
ARC CUTTING
In cases of small circle or arc cutting, use a lower cutting speed
than for ordinary straight cutting.
NOTE: Too much pressure may break the blade when cutting
in a circular motion.
CENTER CUTTING
To cut in the center of a board, rest the base of the tool on the
board as shown in fig. 7, so that the blade does not touch it. Then
turn the switch on and slowly lower the moving blade against the
board.
For materials other than wood, a starting hole must be drilled first.
BEVEL CUTTING (Fig. 5, 6)
1. Loosen the hex. socket head bolt (8) at the bottom of the base
plate (9) by using the hex. key wrench (6).
2. Align the bottom line of the housing to the angle scale (10) on
the base plate, and then fasten the hex. socket head bolt firmly.
Bevel cutting of 0 - 45° can be achieved easily.
MAINTENANCE
After use, check the tool to make sure that it is in top condition.It
is recommended that you take this tool to a RYOBI Authorized
Service Center for a thorough cleaning and lubrication at least
once a year.
DO NOT MAKE ANY ADJUSTMENTS WHILE THE MOTOR IS
IN MOTION.
ALWAYS REMOVE THE BATTERY FROM THE TOOL BEFORE
CHANGING REMOVABLE OR EXPENDABLE PARTS
(BIT...ETC.), LUBRICATING OR WORKING ON THE UNIT.
WARNING!
To ensure safety and reliability, all repairs should be performed by
an AUTHORIZED SERVICE CENTER or other QUALIFIED
SERVICE ORGANIZATION.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
5
Advertisement
Table of Contents
