Commander Mode - Nissin MG80 Pro Instruction Manual

Commander Mode

Pairing Setting
To perform wireless shooting, set the Nissin MG80 Pro as commander and or
NAS slave with the following procedure. When pairing completed, both of them
memorized the data and no need to pair again after switching.
Step 1: Switch off all unit
Nissin flash Di700A
1. Hold the "Set" and Power "ON/OFF" buttons for 3 seconds at the same time.
2. "Beep" sound persists until the pairing signal received.
3. Nissin Di700A will automatically be changed into wireless slave mode
after pairing completed.
Nissin flash i60A
1. Hold the Panel Lock key and the ON/OFF button of Nissin i60A
for 3 seconds at the same time.
2. "Beep" sound persists until the Pairing complete.
Nissin flash MG10 / MG8
1. Rotate "Ch" channel dial to "A" auto channel mode.
2. Hold "Open" button and the power button for 3 seconds.
3. "Beep" sound persists until the Pairing signal received from commander.
Nissin flash MG80 Pro (Slave mode)
1. Switch on MG80 Pro, press Power button for 3 seconds to open mode menu,
select Slave Mode then turn off.
2. Hold the Panel Lock key and the ON/OFF button of Nissin MG80 Pro
at the same time for 3 seconds.
3. "Beep" sound persists until the pairing complete.
Nissin Air R Receiver
1. Rotate "Ch" channel dial to "Auto" auto channel mode.
2. Hold power button for 3 seconds
3. "Beep" sound persists until the pairing complete.
12