Table of Contents
Advertisement
1. Numerical Data
Numerical data is programmed by entering a number from 0-255 on the
numeric keys of the system keypad. To view the data in a location, a binary
process is used. With this process, the LED=s for zones 1 through 8 are
utilized, and the numeric equivalents of their illuminated LED=s are added
together to determine the data in a programming location. The numeric
equivalents of these LED=s are as follows:
Zone 1 LED = 1
Zone 2 LED = 2
Zone 3 LED = 4
Zone 4 LED = 8
Example: If the numerical data to be programmed in a location is "66", press
[6]-[6] on the keypad. The LED=s for Zone 2 and Zone 7 will become
illuminated indicating 66 is in that location (2 + 64 = 66). Once the data is
programmed, press the [r] key to enter the data and advance to the next
segment of that location. After the last segment of a location is programmed,
pressing the [r] key will exit that location, turn the "Ready" LED off and the
"Armed" LED on. As before, you are now ready to enter another programming
location. If an attempt is made to program a number too large for a particular
segment, the keypad sounder will emit a triple beep, indicating an error, and
remain in that segment awaiting a valid entry.
2. Feature Selection Data
Feature selection data will display the current condition (on or off) of eight
features associated with the programming location and segment selected.
Pressing a button on the touchpad (1 - 8) that corresponds to the "feature
number" within a segment will toggle (on/off) that feature. Pressing any
numeric key between [1] and [8] for selection of a feature will make the
corresponding LED illuminate (feature ON). Press the number again, and the
LED will extinguish (feature OFF). You will see that numerous features can
be selected from within one segment. For instance, if all eight features of a
segment are desired, pressing [1]-[2]-[3]-[4]-[5]-[6]-[7]-[8] will turn on
LED's 1 thru 8 as you press the keys, indicating that those features are
enabled. LCD Keypad Users Note: The numbers of the enabled features
will be displayed.
hyphen.
After the desired setting of features is selected for this segment,
press the [r] key. This will enter the data and automatically advance to the
next segment of the location. When you are in the last segment of a location
and press the [r] to enter the data, you will exit that location. This will now
turn the "Ready" LED off and the "Armed" LED on. As before, you are now
ready to enter another programming location.
However, the features not enabled will display a (-)
7
Zone 5 LED = 16
Zone 6 LED = 32
Zone 7 LED = 64
Zone 8 LED = 128
Advertisement
Table of Contents
